Volume 8, Issue 2, June 2020, Page: 22-27
Effect of Graphene Oxide Precursor Loading on the Surface of Melamine-Formaldehyde/rGO Sponge with Enhanced Ultra-Hydrophobicity for Oils Removal
Natcha Jirasuttisarn, Department of Chemistry, Faculty of Science, King Mongkut’s Institute of Technology Ladkrabang, Bangkok, Thailand
Chaval Sriwong, Department of Chemistry, Faculty of Science, King Mongkut’s Institute of Technology Ladkrabang, Bangkok, Thailand; Smart Materials Research and Innovation Unit, Faculty of Science, King Mongkut’s Institute of Technology Ladkrabang, Bangkok, Thailand
Received: Apr. 21, 2020;       Accepted: May 6, 2020;       Published: May 14, 2020
DOI: 10.11648/j.nano.20200802.12      View  138      Downloads  52
Abstract
This work presented a facile, green and effective method to prepare the ultra-hydrophobic melamine-formaldehyde (MF) sponge loaded with reduced graphene oxide (rGO) by a conventional heating method using the various contents of graphene oxide, GO (1, 3, 5, 10 and 15 mg) precursor, and vitamin C as a reducing agent. These GO precursors were used to increase the roughness of the MF/rGO sponge surfaces. Then GO precursor, rGO, pristine MF sponge and as-prepared MF/rGO sponge samples were confirmed and characterized by Fourier transform infrared spectroscopy (FTIR), Raman spectroscopy, scanning electron microscopy (SEM), transmission electron microscopy (TEM) and water contact angle techniques. Moreover, the adsorption capacity, oils removal performance and recyclability of MF/rGO sponges were also investigated. The results showed that the water contact angle values were increased from 131 to 144.1 upon the increasing of GO precursor loading. The highest water contact angle (144.1) exhibited the ultra-hydrophobic property by the sponge prepared using GO loading as 10 mg (MF/rGO-10 mg). The adsorption capacity (Qe) of the MF/rGO-10 mg sponge was higher than 102 g.g-1 for all the oils removal tested (palm oil, gasoline, diesel and lubricant oil), and had the highest value was about 112 g.g-1 for lubricant oil. Besides, MF/rGO sponge can be well-recycled use up to 10 times for all oils removal. Therefore, this study provides a new alternative method to prepare the MF sponge loaded with rGO (MF/rGO), which can be used and reused for the cleanup of oil spillages from water.
Keywords
Graphene Oxide (GO), Reduced Graphene Oxide (rGO), Melamine-Formaldehyde (MF) Sponge, Vitamin C, Ultra-Hydrophobicity, Oil Spills
To cite this article
Natcha Jirasuttisarn, Chaval Sriwong, Effect of Graphene Oxide Precursor Loading on the Surface of Melamine-Formaldehyde/rGO Sponge with Enhanced Ultra-Hydrophobicity for Oils Removal, American Journal of Nano Research and Applications. Vol. 8, No. 2, 2020, pp. 22-27. doi: 10.11648/j.nano.20200802.12
Copyright
Copyright © 2020 Authors retain the copyright of this article.
This article is an open access article distributed under the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0/) which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Reference
[1]
J. Wang, and G. Geng (2015) “Highly recyclable superhydrophobic sponge suitable for the selective sorption of high viscosity oil from water”, Marine Pollution Bulletin. 57: 118-124.
[2]
Y. Lu, Y. Wang, L. Liu, and W. Yuan (2017) “Environmental-friendly and magnetic/silanized ethyl cellulose sponges as effective and recyclable oil-absorption materials”, Carbohydrate Polymers. 173: 422-430.
[3]
T. Xu, Z. Wang, Y. Ding, W. Xu, W, Wu, Z. Zhu, and H. Fong (2018) “Untralight electrospun cellulose sponge with super-high capacity on absorption of organic compounds”, Carbohydrate Polymers. 179: 164-172.
[4]
S. Yang, L. Chen, L. Mu, and P-Cheng Ma (2014) “Magnetic graphene foam for efficient adsorption of oil and organic solvents”, Journal of Colloid and Interface Science. 430: 337-344.
[5]
A. P. Periasamy, W. P. Wu, R. Ravindranath, P. Roy, G. L. Lin, and H. T. Chang (2017) “Polymer/reduced graphene oxide functionalized sponges as superabsorbents for oil removal and recovery”, Marine Pollution Bulletin. 114: 888-895.
[6]
X. Lu, Z. Cui, W. Wei, J. Jiang, J. Huang, and J. Liu (2016) “Constructing polyurethane sponge modified with silica/graphene oxide nanohybrids as a ternary sorbent”, Chemical Engineering Journal. 284: 478-486.
[7]
C. Liu, J. Yang, Y. Tang, L. Yin, H. Tang, and C. Li (2015) “Versatile fabrication of the magnetic polymer-based graphene foam and application for oil-water separation”, Colloids and Surface A: Physicochemical and Engineering Aspects. 468: 10-16.
[8]
M. Peng, G. Chen, G. Zeng, A. Chen, K. He, Z. Huang, L. Hu, J. Shi, L. Yuan, and T. Huang (2018) “Superhydrophobic kaolinite modified graphene oxide-melamine sponge with excellent properties for oil-water separation”, Applied Clay Science. 163: 63-71.
[9]
Z. Rahmani, M. T. Samadi, A. Kazemi, and A. M. Rashidi (2017) “Nanoporous graphene and graphene oxide-coated polyurethane sponge as a highly efficient, Superhydrophobic, and reusable oil spill absorbent”, Journal of Environmental Chemical and Engineering. 5: 5025-5032.
[10]
Y. He, Y. Liu, T. Wu, J. Ma, X. Wang, Q. Gong, W. Kong, F. Xing, Y. Liu and J. Gao (2013) “An environmentally friendly method for the fabrication of reduced graphene oxide foam with a super oil absorption capacity”, Journal of Hazardous Materials. 260: 796-805.
[11]
T. Guo, X. Chen, L. Su, C. Li, X. Huang, and X. Z. Tang (2019) “Stretched graphene nanosheets formed the obstacle walls in melamine sponge toward effective electromagnetic interference shielding applications”, Materials and Design. 182: 108029.
[12]
C. Zhang, H. Li, Z. Zhuo, R. Dugnan, C. Sun, Y. Chen, and H. Liu (2017) “Facile fabrication of ultra-light and higly resilient PU/RGO foams for microwave absorption”, RSC Advances. 7: 4132.
[13]
C. Phompet, C. Sriwong, and C. Ruttanapun (2019) “Mechanical, dielectric, thermal and antibacterial properties of reduced graphene oxide (rGO)-nanosized C3AH5 cement nanocomposites for smart cement-based materials”, Composites Part B. 175: 107128.
[14]
C. Sriwong, K. Choojun, and S. Kongtaweelert (2017) “Investigation of the influences of reaction temperature and time on the chemical reduction of graphene oxide by conventional method using vitamin C as a reducing agent”, Materials Science Forum. 909: 225-230.
[15]
S. Gupta, W. D. He, and N. H. Tai (2016) “A comparative study on superhydrophobic sponges and their application as fluid channel for continuous separation of oils and organic solvents from water”, Composites Part B. 99-106.
[16]
L. Dashairya, A. Sahu, and P. Saha (2019) “Stearic acid treated polypyrrole-encapsulated melamine formaldehyde superhydrophobic sponge for oil recovery”, Advanced Composites and Hybrid Materials. 2: 70-82.
[17]
D. Li, M. B. Muller, S. Gilje, R. B. Kaner, and G. G. Wallace (2008) “Process able aqueous dispresions of graphene nanosheets”, Nature Nanotechnology. 3: 101-105.
[18]
Y. Liu, J. Ma, T. Wu, X. Wang, G. Huang, Y. Liu, H. Qiu, Y. Li, and W. Wang (2013) “Cost-effective reduced graphene Oxide-coated polyurethane sponge as a highly efficient and reusable oil-absorbent”, ACS Applied Materials & Interfaces. 5: 10018-10026.
[19]
L. Qiu, R. Zhang, Y. Zhang, C. Li, Q. Zhang, and Y. Zhou (2018) “Superhydrophobic, mechanically flexible and recyclable reduced graphene oxide wrapped sponge for highly efficient oil/water separation”, Frontiers of Chemical Science and Engineering. 12: 390-399.
[20]
N. Yousefi, K. Wong, Z. Hosseinidoust, H. O. Sørensen, and N. Tufenkji (2018) “Hierarchically porous, ultra-strong reduced graphene oxide-cellulose nanocrystal sponges for exceptional adsorption of water contaminants”, Nanoscale. 10: 7171-7184.
Browse journals by subject